Marked leak location
A spot on the floor or wall you can see
Leak detection and repair Aliso Viejo CA homeowners can call at the first sign of a wet wall, a climbing water bill, or a warm spot on the slab. We use electronic leak detection Aliso Viejo equipment to pinpoint the break before we open anything, then repair the line and pressure-test it before we leave. One visit, one clear price.
Every leak call includes the detection work and the repair of the located leak. Here is what is part of the standard visit, so you know what you are paying for before we arrive.


We trace leaks in houses, condos, and townhomes across Aliso Viejo, from a warm spot on the slab to a pinhole behind a laundry wall. You get the leak located, the repair explained, and the line tested before we leave.
We handle leak calls for shops, offices, and multi-unit buildings where a water loss interrupts business and damages shared walls. Detection comes first so the repair stays small and the building stays open.
Leak detection and repair Aliso Viejo CA is the process of locating a hidden water loss with acoustic and electronic instruments, then opening only the section that needs fixing and restoring the pipe to code. It covers slab leaks under the foundation, pinholes in copper pipe, failed PEX fittings, and supply lines behind drywall. We start by isolating the system, then listen, meter, and thermal-scan until the leak has an exact address.
Aliso Viejo homes built through the 1990s and 2000s are now hitting the age where copper pipe thins and slab leaks show up as a hot spot on the floor or a water bill that jumps $80 in a month. If you search hidden leak detection near me Aliso Viejo, you want a crew that reads the meter and the moisture map instead of cutting drywall on a guess. We do that daily across Orange County.
Find the leak with instruments first, then open only what the repair needs.
Five steps, most of them finished in a single visit. Here is exactly what happens from the phone call to the final pressure test.

Listens for the sound of pressurized water escaping a pipe, which lets us trace a slab or buried leak to within a few inches before any cutting.

Shows temperature differences on floors and walls, which is how a hot water slab leak gets spotted as a warm patch without opening the slab.

Inspects drain and sewer lines from the inside so we can see cracks, root intrusion, and joint failures instead of guessing from the surface.

Makes the repair joint. Press fittings go on fast with a press tool, while soldered copper joints use a torch and solder for a permanent connection.

Cuts and holds the line during repair so the new section fits cleanly and the joint seals at working pressure.

Confirms how far water has traveled in a wall or cabinet base, which tells us what needs drying and what can stay.

We shut every fixture and watch the meter to confirm whether water is being lost on the supply side or the drain side. This single test rules out half the possibilities before any instrument comes out of the truck.

We pressurize one run at a time and watch for a pressure drop. The zone that loses pressure holds the leak, which narrows the search to a single line instead of the whole house.
We run a full isolation and detection visit, document the findings with photos and meter readings, and repair anything active. You get a clear record for the transaction instead of a vague inspector note. The repair is documented and pressure-tested, which keeps the sale moving and answers the buyer's question with evidence.
We isolate the fixture, check the fill and flush valves, and confirm whether the loss is the toilet or a line behind it. A running toilet often masks a second, smaller leak. You get the real source fixed, not just the obvious one, and the bill settles back to normal within a billing cycle.
We shut the water off, contain the damage, and repair the burst section with copper or PEX. The line is pressure-tested before the wall is closed, and we tell you what to dry out. Water is back on the same day in most cases, and the wall cavity is dry before patching starts.
We isolate the irrigation and main service lines, locate the break with acoustic equipment, and repair the section. Root intrusion and soil movement are common causes here. The soggy patch dries out, the meter stops moving, and the line holds pressure through a full test.
Aliso Viejo sits on ground that moves, and the housing stock tells the story. Homes built through the 1990s and 2000s are now at the age where copper pipe thins and pinhole leaks start showing up in walls and under slabs. The warm, dry summers here also push irrigation systems hard, so service lines and sprinkler runs take a beating. We run water leak repair Aliso Viejo CA calls with acoustic detection first, because opening a slab on a guess is expensive and usually wrong. Water pressure above 80 psi is another common culprit in this area, and we check it during every repair so the next pipe does not fail the same way. If you need same-day water leak detection Aliso Viejo CA, call early in the day and we can usually fit the visit.
A Westpark homeowner had a warm patch in the hallway and a water bill up $85 in one month. The meter kept moving with every fixture off, which pointed to a hot water line under the slab.
We isolated the hot side, marked the break with acoustic and thermal detection, and repaired the line through one 18-inch opening. The meter stopped moving, and the tile was reset the next day.
We checked water pressure and recommended a regulator set to 65 psi, which protects the remaining copper from the same failure.
A Town Center condo had a musty smell in the laundry closet and paint bubbling near the baseboard. The leak had been soaking the drywall for weeks before it showed on the surface.
We traced the pinhole to a copper section behind the wall, cut one clean opening, and soldered in a new piece. The pressure test held at 80 psi, and the cavity dried out over three days.
We photographed the repair and left the drywall patch to the homeowner's painter, with the joint location marked for future reference.
A Glenwood home lost water pressure overnight and found wet drywall in the garage. A supply line had burst where it ran along an exterior wall during a cold night.
We shut the water off, replaced the burst section with PEX tubing, and pressure-tested the run before closing the wall. Water was back on within four hours of the call.
We insulated the exterior run and checked the rest of the line for thin spots so the same section does not fail next winter.
Most leak calls fall into a handful of patterns. Here are the ones we see most in Aliso Viejo, what happens if they are ignored, and how we handle them.

We isolate the hot side, use acoustic and thermal detection to mark the break, then repair or reroute the line. The floor stays intact except for the one opening needed to reach the pipe. A hot water slab leak can lift tile, warp laminate, and drive the water bill up $60 to $100 a month while the slab stays wet underneath.

A meter test confirms the loss, and hidden leak detection near me Aliso Viejo searches usually trace it to a pinhole or a failed fitting. We repair the section and pressure-test the run before leaving. A hidden supply leak wastes 20 to 40 gallons a day and can saturate a wall cavity until drywall and framing start to fail.

We camera the line where needed, find the source, and repair the pipe. The area is dried and documented so you know the cavity is sound before anything gets closed back up. A slow drain or supply leak behind a cabinet base breeds mold within days and can rot the cabinet floor beyond repair.

We test pressure at the meter and at fixtures, locate the restriction or leak, and repair it. If pressure is running above 80 psi, we recommend a regulator to protect the whole system. A partial blockage or a leaking line can starve fixtures and stress the water heater, shortening its life and raising energy costs.
A pinhole in a copper line can waste 20 to 40 gallons a day. We isolate the run, confirm the loss on the meter, and shut it down before it reaches drywall or a cabinet base. Most active leaks are stopped the same day we arrive.
Electronic leak detection Aliso Viejo service means we mark the leak within a few inches before a saw touches anything. That turns a two-wall repair into a single clean cut, and it saves you patching and paint on top of the plumbing bill.
A slab leak under tile or laminate can lift the floor within days. We locate the break, repair or reroute the line, then dry-test the run at working pressure so the slab stays put. Catching it early is the difference between a pipe repair and a floor replacement.
We quote the detection and the repair together before we start, so there is no surprise when the wall opens. If the fix turns out simpler than expected, the price reflects that. You approve the number, then we work.
Typical 2026 pricing in Aliso Viejo runs $180 to $450 for the detection visit, with the repair quoted once the leak is located. A straightforward pinhole repair might add $250 to $600, while a slab leak repair or reroute can run $1,200 to $3,500 depending on access and line length. We quote detection and repair together before we start, so the number you approve is the number you pay. Affordable leak repair Aliso Viejo California pricing starts with knowing the real scope, and that is what the detection visit gives you.
What your estimate is based on
$180 - $3,500 depending on scope The detection visit is what keeps the repair small. Finding the leak before cutting is the difference between one opening and three, and that saves more than the detection fee on almost every slab job.
Clear records you can keep and share.
A spot on the floor or wall you can see
The reading before and after the repair
Images of the finished joint for your records
A leak that shows on the surface has usually been running for a while. The meter test tells you whether the loss is on the supply side or the drain side before any instrument comes out.
Shut every fixture and watch the meter. If it moves, water is escaping somewhere on the supply side. That single test narrows the search to one system.
Pressurized water escaping a pipe makes a sound that acoustic equipment can follow. It works through slab and soil, which is why we mark the spot before cutting.
The smallest opening that reaches the leak is the goal. Less cutting means less patching, less drying, and a repair that holds without disturbing the rest of the floor.

Outside these areas? Call and ask, we will tell you straight. 949-920-1218
Most leak detection visits in Aliso Viejo run $180 to $450 in 2026, and the repair is quoted separately once we know what we are fixing. Slab leaks and hidden lines behind tile sit at the higher end because they take longer to isolate. We give you the detection price before we start, so the number does not move.
The three signs are a warm spot on the floor, the sound of running water when every fixture is off, and a water bill that jumps without a change in use. Any one of them is worth a meter test. We isolate the system, watch the meter, and confirm the loss before recommending a slab leak repair in Aliso Viejo, California.
Sometimes, yes. A supply leak under a slab can often be rerouted through the attic or exterior wall, which avoids opening the interior drywall entirely. Leaks inside a wall usually need one small access opening, but electronic detection lets us keep it to a single cut instead of a search pattern.
The common causes here are copper pinhole corrosion in homes built in the 1990s, failed PEX crimp fittings, high water pressure above 80 psi, and root intrusion on older service lines. Aliso Viejo's soil movement also stresses buried lines over time. We check pressure and line condition during the repair so the same failure does not repeat.
A running meter with everything off means water is going somewhere it should not. Call 949-920-1218 and we will isolate the system, find the leak, and quote the repair before we open anything. Same-day visits are common.
Call 949-920-1218 to book a plumber in Aliso Viejo. We answer emergency calls around the clock and schedule same-day slots for most standard repairs. Tell us what is happening and we will tell you what it takes to fix it.